Rare Spares
Couldn't load pickup availability
When restoring a bonnet latch system, the upper catch hardware is just as important as the lower lock. This Bonnet Safety Catch, Plunger & Spring Kit is suited to Holden EJ, EH, HD and HR models and provides the key hardware fitted to the underside of the bonnet panel, helping the bonnet shut firmly, pop up slightly once released, and remain held by the safety catch until manually opened.
Remove the bonnet plunger and spring first to make fitting the safety catch rivet easier.
Screw the bonnet nut onto the plunger thread. (Lock nut is not supplied with these parts)
Place the retainer onto the plunger with the flat side facing down.
Fit the spring over the plunger.
Screw the plunger into the bonnet.
Adjust the plunger by screwing it in or out until the bonnet closes level with the guard.
Tighten the lock nut against the bonnet.
Place one end of the safety-catch spring into the hole in the safety catch.
Position the safety catch on the bonnet, ensuring the other end of the spring is under tension against the bonnet.
Push the rivet through the bonnet brackets and the safety catch.
Support the rivet, then peen or flare its end against the washer to secure it.
The Bonnet Safety Catch, Plunger & Spring Kit is a practical choice for replacing worn, incomplete or corroded upper bonnet latch hardware and restoring secure, confident bonnet operation.
