Skip to product information
1 of 1

Rare Spares

Bonnet & Front Guard Eyebrow Moulding Kit Holden HK HT HG trim - M1010

Bonnet & Front Guard Eyebrow Moulding Kit Holden HK HT HG trim - M1010

Regular price $289.95 AUD
Regular price Sale price $289.95 AUD
Sale Sold out
Tax included.

Give the front of your Holden HK, HT or HG a complete brightwork refresh with this Bonnet & Front Guard Eyebrow Moulding Kit. Bringing together the centre bonnet moulding and matching left- and right-hand guard eyebrow mouldings, the kit recreates the distinctive continuous polished trim line across the front panels.


  • Complete Brightwork Assembly: Includes one main bonnet moulding, one left-hand guard eyebrow moulding and one right-hand guard eyebrow moulding for a coordinated front-end appearance.

  • Comprehensive Mounting Hardware Included: Supplied with 22 slide-on nylon moulding clips, 22 aluminium pull rivets, two end clips, two flat washers and two self-tapping screws to support installation of all three trim sections.

  • Polished, Durable Exterior Mouldings: Mouldings are stamped and roll-formed from premium automotive-grade stainless steel or high-tensile chrome-finished aluminium, with a deep mirror-polished surface that resists weathering, pitting, fading and road grime.

  • Flush Alignment And Panel Protection: The mouldings follow the bonnet and guard contours to create a uniform trim line, while nylon clips and rivets help isolate the brightwork from painted panel surfaces to reduce rubbing and moisture retention around mounting points.


  • Fitment Guide:

Select the correct-size rivets before drilling the bonnet and guard mounting holes.

Drill the mounting holes as required.

Ensure all holes are clear of debris.

Use a pop-rivet gun to install the rivets into the bonnet and guard panels.

Place each clip over the head of a rivet.

Push each clip sideways to lock it onto the rivet.

Push the end clips into the bonnet moulding with the flat side facing the bonnet.

Use the bonnet to align the end clips with the bonnet mounting holes before fitting the moulding.

Where possible, hook the moulding under the edge of the clips.

Push the moulding over the clips until it sits flush against the panel.

Fit the washers and screws to the bonnet moulding.

Tighten the screws until each screw head just touches the washer against the bonnet.


  • Fitment Note: Do not force the moulding over the clips, as damage may occur - Use your thumbs, or place a folded soft rag over the moulding and use the pad of your hand to gently push or tap the moulding over each clip.


The Bonnet & Front Guard Eyebrow Moulding Kit provides the key trim pieces and fastening hardware needed for a clean, cohesive front-end restoration.


View full details